Flexim FLUXUS G704, User Manual, Page: 141 / 257

UMG70XV3-4EN 12.01.2009 141
15 Settings
15.2.2 Medium Pressure
The dependency of the properties of a medium on the pressure can be taken into ac-
count.
This display is indicated only if in
SPECIAL FUNCTION\SYSTEM SETTINGS\MEASUR-
ING
the
GAS MEASURING
has been deactivated. If
GAS MEASURING
is activated, the
medium pressure will always be requested in the program branch
PARAMETER
.
15.2.3 Measuring Point Number
15.2.4 Transducer Distance
If
ON
is selected, the medium pressure will be requested in
the program branch
PARAMETER
.
If
OFF
is selected, 1 bar will be used for all calculations.
Note!
It is reasonable for documentation purpose to enter the medium pres-
sure even if no pressure dependent characteristics are stored in the
flowmeter.
Select
1234
if the measuring point is to be identified only
by numbers, point and dash.
Select
 if the measuring point is to be identified by
the ASCII editor.
recommended adjustment:
USER
•
USER
will be selected if the measuring point is always
the same.
•
AUTO
can be selected if the measuring point often
changes.
In the program branch
MEASURING
, the recommended
transducer distance will be displayed in parentheses, fol-
lowed by the entered transducer distance if the recom-
mended and the entered transducer distance are not iden-
tical.
During transducer positioning in the program branch
MEA-
SURING
• only the entered transducer distance will be displayed if
TRANSD. DISTANCE\USER
is selected and the recom-
mended and the entered transducer distances are iden-
tical
• only the recommended transducer distance will be dis-
played if
TRANSD. DISTANCE\AUTO
is selected.
Fluid pressure
off >ON<
Meas. Point No.:
(1234) >(

)<
Transd. Distance
auto >USER<
Transd.Distance?
(50.8) 50.0 mm
Transd.Distance?
50.8 mm