Flexim FLUXUS G704, User Manual, Page: 140 / 257

140 UMG70XV3-4EN 12.01.2009
15 Settings
15.2.1 Pipe Circumference
Select
ON
if the pipe circumference has to be entered in-
stead of the pipe diameter in the program branch PARAM-
ETER. Press ENTER.
If
ON
is selected for
PIPE CIRCUMFER.
, the outer pipe di-
ameter will be requested in the program branch
PARAME-
TER
nevertheless.
To select the menu item
PIPE CIRCUMFER.
, enter 0 (ze-
ro). Press ENTER.
The value displayed in
PIPE CIRCUMFER.
is calculated
on the basis of the last displayed value of the outer pipe di-
ameter.
example: 100 mm *

= 314.2 mm
Enter the pipe circumference. The limits for the pipe cir-
cumference will be calculated on the basis of the limits for
the outer pipe diameter.
During the next scroll through the program branch
PARAM-
ETER
, the outer pipe diameter corresponding to the en-
tered pipe circumference will be displayed.
example: 180 mm :

= 57.3 mm
Note!
The pipe circumference is edited temporarily only. When the flowme-
ter switches back to the display of the pipe circumference (internal re-
calculation), slight rounding errors may occur.
example: entered pipe circumference: 100 mm
displayed outer pipe diameter: 31.8 mm
When the flowmeter switches back to the display of the pipe circumference
(internal recalculation), 99.9 mm will be displayed.
Pipe Circumfer.
off >ON<
Outer Diameter
100.0 mm
Pipe Circumfer.
314.2 m m
Pipe Circumfer.
180 mm
Outer Diameter
57.3 mm