Page 42
Vision Sensor SBSI/SBSC-EN, 8062650 - 1607b - 13/09/2016
Vision Sensor Manual
H) Status bar
Different status information including Mode / Name of SBS / Active job. In Run Mode: Cycle time / cursor
x/y location and pixel intensity / individual I/O on /off indication (like configured in "Output/Digital
output").
4.3.1 Job Setup
Configuring a job
To configure a job, edit the job entry in the "Select job" (G) field or e.g. create a new job. Set global
parameters here, such as shutter, exposure or the resolution which is valid for the entire job.
For Job- setup: in Setup/Job edit or generate a new job in field "Jobs" (G),
Fig. 32: Vision Sensor Configuration Studio Job
One job contains all settings and parameters necessary to perform a specific inspection task.
Jobs are created here, and several jobs can be stored in the SBS . All global settings, valid for each
individual job, e.g. shutter, gain, illumination settings etc. are also carried out here.
l
The following basic image settings should first be made to ensure a high-contrast and sharp image:
* Image brightness: Set shutter or amplification, see Job/General
* Image sharpness: Focus setting via the screw on the back of the SBS camera itself
l
When delivered, the factory settings are trigger mode = "free run" (see Job/General) and image
acquisition mode = "continuous" . A new image is continuously displayed for easier focus and
brightness set up.
l
The subsequent setting of alignment and detectors should preferably be carried out in single image
mode, as all settings are then based on a master image and image collection is not continuously carried
out.
Summary of Contents for SBSC-EN
Page 1: ......
