Page 176
Vision Sensor SBSI/SBSC-EN, 8062650 - 1607b - 13/09/2016
Vision Sensor Manual
By usage of binary job switch the desired job number must be represented binary coded via the selected
inputs. Therefore in this mode to switch between 2 jobs minimum 2 inputs are necessary.
In case of Job change Job 1 or 2 a high level cause’s evaluation according to job 2, a low level produces
evaluation according to job 1. In this way with only one input two the switching between two jobs can be
done.
Fig. 175: Input timing, Job change via Binary / Job 1 or 2
4.6.4.2.3 Input: Job 1 ... n
For switching between jobs via impulses. Only possible when Ready = high. With the first impulse Ready
is set to low. Impulses are counted until the first delay of >= 50ms and then switches to the appropriate
job. Ready remains low until switch-over to the new job occurs. If the option “Job change confirm” is
used, this signal occurs after the job change, and hereafter "Ready" is set high again. During Job Change
over binary inputs there must not be sent any trigger signal. Pulse length for job change should be 5 ms
pulse and 5 ms delay.
If possible job change should be made by binary coded signals like in fig. 2, this is the faster way.
Fig. 176: Input timing, Job 1 ... n
Attention!
At Job switch please take care of the following:
- All Jobs must have the same setting for job change
Summary of Contents for SBSC-EN
Page 1: ......
