Vision Sensor SBSI/SBSC-EN, 8062650 - 1607b - 13/09/2016
Page 229
Vision Sensor Manual
Step 1:
After the job with all necessary detectors, if so alignment is set up, here the RS422 interface get´s
activated and if necessary it´s parameter are set also.
Fig. 234: Data output RS422
In the example the RS422 interface in the parameter area at the bottom in tab “Interfaces“ get´s activated
by marking the checkbox.
The default settings for Baud rate = 19200 and Logical outputs = 0 remain as they are. Here of course any
other settings can be done which must have its corresponding setting at the other side (at the PC or PLC,
whatever used)
Step 2:
In tab „Output“ the payload data which shall be transferred via RS422 are defined.
In this example this is:
l
Start: „010“
l
Overall result of detector 1
l
Trailer: „xxx“
l
As format „ASCII“ is defined, that makes traceability easier. The function with other payload data or
in binary format works analogue to this example and to the here made settings.
Summary of Contents for SBSC-EN
Page 1: ......
