![background image](http://html1.mh-extra.com/html/fbii/omni-408a/omni-408a_installation-and-setup-gude_547064070.webp)
OMNI-408A Installation and Setup Guide
10–2
Questions 01-10, L1 - RF Device Options
Digit
OPTION
EXPLANATION
0
Disabled
Not applicable
1
1 Zone or Button
Only 1 Zone or 1 Button
2
2 Zones or Buttons
2 Consecutive Zones or 2 Buttons
3
3 Zones or Buttons
3 Consecutive Zones or 3 Buttons
4
4 Buttons
4 Buttons (Keyfobs)
NOTE: Any zones programmed in RF Programming must also be enabled in question 26.
Questions 01-10, L2 - RF Device Type
Digit
TYPE
EXPLANATION
0
Disabled
Not applicable
1
5800 Transmitter 5800 Series Transmitters (select for keyfobs)
9
5816 Transmitter 5816 Transmitter using magnetic relay only
Questions 01-10, L3 through L9 - 5800 Serial Number
For all 5800 RF devices to be used, enter the 7-digit serial number printed on the device.
If an RF device is not to be used, program a “00” into the locations corresponding to the
device.
NOTE: When programming a device that uses multiple zones, you must skip the additional
zones supported by that device by disabling them. For example, if zone 2 has a device that
has been programmed to support three zones, the next two zones must be disabled, and the
following zone must be zone 5.
To disable an RF point that has been previously programmed, you must:
1.
Remove the RF enable for the appropriate zone in question 26; and
2.
Make the first 2 digits in the RF programming for that zone “00.”
Example of RF Programming
In this example of RF Programming, assume that a four-button keyfob is being enabled as
keyfob number 1, the keyfob has a serial number of “A 123 4567," and that only one question
(09) is being programmed at this time.
DESCRIPTION
KEYPAD ENTRY
1. Enter RF programming
*# or Bypass
2. Select question 09 for keyfob 1
09
3. Select the 4 button keyfob option (table L1- RF Device Options)
4
4. Select 5800 transmitter type (table L2 - RF Device Type
1
5.Enter 7-digit serial number from the keyfob as L3 through L9
(ignore letter A at the beginning)
1234567
6. Exit RF Programming
STAY
Below is a completed RF Programming Worksheet for the above example would appear as:
09 RF KEYFOB 1 DEFINITION
4
1
1
2
3
4
5
6
7
Default: 000000000
1
2
3
4
5
6
7
8
9
OPT TYPE
SERIAL NUMBER
Summary of Contents for Omni-408A
