FBII Omni-408A, Installation And Setup Gude, Page: 65 / 96

Section 9 - System Programming
9–31
TWO-WAY VOICE - This trigger activates when line seizure occurs if the event is any of
the following: burglary, fire, duress, keypad panic, keypad fire, or keypad auxiliary. It
does not activate for CS test, openings/closing, trouble, bypass, cancel, or restore. It
deactivates about 1 second before disconnecting the telephone line. Also, at the time of
release, keypad sounders are silenced for the remaining duration of the bell output cycle.
The bell times out or a valid user code terminates.
NOTE: The trigger outputs are limited to approximately 50mA each.
NONINVERT TRIGGER - The trigger output (positive to negative) is normally floating,
and actively sinks (becomes a negative) on activation.
INVERT TRIGGER - The trigger output (positive to negative) is normally sinking
(negative with respect to positive), and actively floats on activation.
QUESTION 29
CS TEST TIME
DEFAULT = 0200
If the control panel transmits a system test at a specific time of day, enter the hour and
minute in military time (24-hour clock) as follows:
Question 29, L1 & L2 - Hour of Day (00 - 23) Default = 02
Enter the hour of the day in military time: 12 A.M. - 12 P.M. (00 - 23).
NOTE: Quick Rule: 00 = Midnight; for times after 12 noon, add 12 hours to obtain the
hour.
Question 29, L3 & L4 - Minute within Hour (00 - 59) Default = 00
Example: To transmit at 5:30 PM, enter a 17 into L1 and L2 and 30 into L3 and L4.
NOTE: The CS Test Interval is selected in question 07, location 3, and is enabled in question
21, locations 3 and 4.
QUESTION 30
CID GROUP NUMBER
DEFAULT = AAAA
Question 30, L1 & L2 - Account 1 Group Number Default = AA
Question 29, L1 & L2 - Account 2 Group Number Default = AA
This question contains the group number that is to be sent in Contact ID format. L1 and L2
contain the group number that is sent when account number 1 is used. L3 and L4 contain the
group number that is sent when account number 2 is used.