9–1
S E C T I O N 9
System Programming
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section
♦
General Information
♦
Programming Questions - Installer Programming
♦
Zone Programming
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
You can program the system in either of the following methods:
•
Directly, through the keypad
•
Remotely, using the EZ-MATE PC DOWNLOADER Model 7700
UL
The EZ-Mate Downloader has not been tested for UL applications.
This section describes how to program the system through the keypad. (The EZ-MATE PC
DOWNLOADER includes documentation describing its programming procedures.) Keypad
programming is accomplished by understanding the “Programming Questions - Installer
Programming” paragraphs below and completing the Appendix B: OMNI-408A System
Programming Worksheet. There are 38 total programming questions, numbered 01 through
37 and 00.
Within each question, there are several locations labeled L1, L2, etc. for data entry. The
system is shipped from the factory with specific default values, which were selected for a
typical installation. If the default values are suitable for your installation, programming can
be simplified. The default values are listed with each programming question.
Summary of Contents for Omni-408A
