FBII Omni-408A, Installation And Setup Gude, Page: 18 / 96

OMNI-408A Installation and Setup Guide
4–2
Mounting Directly to Control Panel Enclosure
If the control panel enclosure has a keypad cutout on the front face, remove the cutout and
mount the plate to the enclosure's face via HOLES “A” (see Figure 4) with the four screws
and nuts provided.
Mounting Directly to an Electrical Junction Box
The plate can be mounted directly to a single- or double-gang electrical junction box. Use the
screw holes provided and HOLES “B” for a single-gang box or HOLES “A” for a double-gang
box.
Mounting Directly to a Wall or Other Surface
Provide a wiring hole in the mounting surface. Position the plate's WIRING OPENING over
the hole and mounting plate, using HOLES “A” and/or “B” in conjunction with appropriate
mounting hardware (not provided) for the type of surface.
1. Complete the keypad wiring as required for the control with which the keypad is to be
used.
2. Replace the keypad cover assembly on the rear plate. Starting at the upper edge of the
plate, engage the plate's two HOLDING HOOKS (see Figure 4) into the recesses provided
for them inside the upper edge of the cover assembly. Snap the lower edge of the cover
assembly and the lower edge of the cover onto the two SNAP HOOKS at the lower edge of
the plate.
NOTE: If desired, cover and plate can be further secured together by inserting a screw
(provided) into the SLOT at the keypad's lower edge.
NOTE: When surface mounting the keypad and using screws with heads larger than the
screws provided with the unit, place electrical tape over the screws to prevent them from
interfering with the keypad operation.