FBII Omni-408A, Installation And Setup Gude, Page: 67 / 96

Section 9 - System Programming
9–33
QUESTION 33
RF REMOTE KEYFOB 3 BUTTON DEFINITIONS
DEFAULT = 0000
Question 33, L1 - RF Remote Keyfob 3 Button 1 Default = 0
Question 33, L2 - RF Remote Keyfob 3 Button 2 Default = 0
Question 33, L3 - RF Remote Keyfob 3 Button 3 Default = 0
Question 33, L4 - RF Remote Keyfob 3 Button 4 Default = 0
In locations L1-L4, enter the digit for the desired system options from the table above. See
Figure 6 for keyfob buttons.
QUESTION 34
RF REMOTE KEYFOB 4 BUTTON DEFINITIONS
DEFAULT = 0000
Question 34, L1 - RF Remote Keyfob 4 Button 1 Default = 0
Question 34, L2 - RF Remote Keyfob 4 Button 2 Default = 0
Question 34, L3 - RF Remote Keyfob 4 Button 3 Default = 0
Question 34, L4 - RF Remote Keyfob 4 Button 4 Default = 0
In locations L1-L4, enter the digit for the desired system options from the table above. See
Figure 6 for keyfob buttons.
QUESTION 35
RF REMOTE KEYFOB 5 BUTTON DEFINITIONS
DEFAULT = 0000
Question 35, L1 - RF Remote Keyfob 5 Button 1 Default = 0
Question 35, L2 - RF Remote Keyfob 5 Button 2 Default = 0
Question 35, L3 - RF Remote Keyfob 5 Button 3 Default = 0
Question 35, L4 - RF Remote Keyfob 5 Button 4 Default = 0
In locations L1-L4, enter the digit for the desired system options from the table above. See
Figure 6 for keyfob buttons.
QUESTION 36
RF REMOTE KEYFOB 6 BUTTON DEFINITIONS
DEFAULT = 0000
Question 36, L1 - RF Remote Keyfob 6 Button 1 Default = 0
Question 36, L2 - RF Remote Keyfob 6 Button 2 Default = 0
Question 36, L3 - RF Remote Keyfob 6 Button 3 Default = 0
Question 36, L4 - RF Remote Keyfob 6 Button 4 Default = 0
In locations L1-L4, enter the digit for the desired system options from the table above. See
Figure 6 for keyfob buttons.
QUESTION 37
CS CODES: EXIT PROGRAM, EXIT ERROR, RECENT PANIC Default = AAAA
Question 37, L1 -L2 Exit Programming CS Code
Question 37, L3 - Exit Error CS Code
Question 37, L4 - Recent Panic CS Code
EXIT PROGRAM CS REPORTING - The Exit Program CS Reporting feature is enabled
by placing an event code in question 37, locations 1 and 2. A letter "A" in location 1 disables
the feature. Once enabled, this code is sent ONLY upon exiting keypad programming, by
pressing the [Stay] [1] [3] (default), or [7] [9] (user default) keys. The feature is NOT affected
by the following: remote upload/download, power down/up, hardwire default, system reset,
and entering or exiting other installer modes such as walk test, unattended, and online
download.
EXIT ERROR CS REPORTING - The Exit Error CS Reporting feature is enabled in
question 37, location 3. A letter "A" disables the CS report. During an exit error, this code is
sent after the control panel's entry time expires and the zone goes into alarm. If the system is