FBII Omni-408A, Installation And Setup Gude, Page: 37 / 96

Section 9 - System Programming
9–3
Refer to Section 6 - System Operations for pager programming and operation.
If neither split nor backup reporting is necessary, or if the Pager Follow-Me feature is not
desired, this question may be left at the factory default values and all conditions will be
routed to the primary telephone number only.
QUESTION 03
CALLBACK TELEPHONE NUMBER
DEFAULT = AAAAAAAAAAAAAAAA
Using the table in question 01 to determine valid digits, enter the telephone number
(including area code and/or dialing prefix, if necessary) for this control panel to reach the
callback location. The callback number is the optional location of the EZ-Mate Downloader
where the control panel calls during a remote communications (upload/download, etc.)
session. During remote communications, the programming device and the control panel will
first confirm the CS security code. If it is valid, communications can begin. If you have
programmed a callback number, the control panel hangs up and dials the callback number.
NOTE: If you do not want callback capability, enter AAAAAAAAAAAAAAAA.
QUESTION 04
CS DIALER OPTIONS
DEFAULT = E435
There are 4 locations (L1-L4) within this question, which define various dialer and system
options, as follows:
Question 04, L1
CS Dialer Formats
Default = E
Enter the digit for the desired dialer format from the table below in location L1.
Digit CS REPORTING
FORMAT
FORMAT TRANSMISSION
TYPE
0 3X1 Standard PULSE
1 4x1 Standard PULSE
2 3x1 Extended PULSE
3 4x1 Extended PULSE
4 3x1 Partial Extended PULSE
5 4x1 Partial Extended PULSE
6 3x2 PULSE
7 4x2 PULSE
A ADEMCO 4x2 Express * DTMF
E ADEMCO Point ID * DTMF
* These formats require a high/low handshake frequency from the CS receiver.
For more information on CS reporting formats, refer to Appendix A at the back of this guide.