FBII Omni-408A, Installation And Setup Gude, Page: 39 / 96

Section 9 - System Programming
9–5
Please consult your central station manager to determine the formats and message lengths that
are accepted by the receiver.
UL
European dialing format has not been tested by UL.
SPLIT REPORTING - The Split Reporting option directs all opening and closing signals to
the secondary receiver telephone number. All other conditions (alarms, troubles, restores,
etc.) adhere to the reporting route described in question 01. If Split Reporting is selected, the
secondary receiver telephone number MUST be programmed.
If Local Alarm is desired, no other options need to be disabled (telephone number,
CS codes).
Question 04, L4
K.P. Panic, System Swinger Shutdown, Zone Restore, & System Bell Test Default = 5
Enter the digit for the desired system options from the table below in location L4.
NOTE: The checkmarks highlight which options are selected.
KEYPAD PANIC
SYSTEM DIAL
DELAY
Digit
AUDIBLE SILENT
SYSTEM
SWINGER
SHUTDOWN
TRANSMIT
ZONE
RESTORE
15 SEC 30 SEC
0
9 9
1
9 9
2
9 9 9
3
9 9 9
4
9 9 9
5
9 9 9
6
9 9 9 9
7
9 9 9 9
8
9 9
9
9 9
A
9 9 9
B
9 9 9
C
9 9 9
D
9 9 9
E
9 9 9 9
F
9 9 9 9
KEYPAD SILENT/AUDIBLE PANIC - Determines whether the keypad panic condition [*]
[#] (entered on the keypad) activates the bell and the keypad buzzer. In either case, a signal
is transmitted to the central station if a Panic code has been programmed.
NOTE: The keypad panic condition can be enabled through question 05, location 1.