FBII Omni-408A, Installation And Setup Gude, Page: 68 / 96

OMNI-408A Installation and Setup Guide
9–34
disarmed before entry time expires, the Exit Error code is not sent. If an alarm results, the
zones Alarm code is sent before the Exit Error code.
RECENT PANIC CS REPORTING - This feature is intended to reduce false alarms.
Enable this feature by placing a CS Report code other than "A" in question 37, location 4.
This feature involves only the use of the Model 5804 RF key. This CS code is sent if a
(5804) panic alarm occurs followed within 1 minute by a (5804) arm/disarm type event. The
5804 arm/disarm programmable events include disarm, force arm, force stay arm, force
instant arm, and force stay/instant arm.
Tripping an RF panic starts the 1-minute timer. At this time, the control panel attempts to
send a keypad panic. If an RF arm or disarm event occurs within 1 minute, the panel sends
the Recent Panic CS code upon the execution of the RF arm or disarm.
NOTE: Subsequent RF arms or disarms will not cause additional Recent Panic CS
transmissions.
If the 1-minute timer expires without an RF arm or disarm, the Recent Panic code (recent
close (459) if PID) is not sent, only the initial Panic code.
QUESTION 00
INSTALLER CODE
DEFAULT = 2468
There are 4 locations (L1 - L4) in this question. Enter any 4 digits (0-9 Installer code
desired). This code is used to ENTER the system Programming mode via the keypad.
Typically, each installing company uses a unique Installer code in order to prevent
unauthorized people from gaining access to their panels.