FBII Omni-408A, Installation And Setup Gude, Page: 6 / 96

vi
Feature Summary of Version 1
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
The following system feature are supplied in Version 1:
Exit Bypass – This feature allows any delay zone or interior that is violated at the end of exit
time to be bypassed for that armed period if the bit is set. This feature, if enabled, takes
precedence over exit error (question 26, location 4, bit 3).
Pager/Follow-Me – This feature allows the end user to access a user-programmable phone
number that can serve as a pager number or forwarding (site) number where the user can receive
digital messages from the OMNI-408A that are a result of programmable events occurring on the
system.
Bell Test from RF Keyfobs – This feature, if enabled, will activate bell test on arming/disarming
only from keyfobs. Arming/disarming from the keypad via user codes or quick function will not trip
the bell test (question 05, location 4, bit 2).
RF Board Detect – The panel senses if the ZR401 RF board is attached to the control panel. This
option is only viewable through the downloader.
Bell Test on Arming – If the "bell test chirp" is selected (question 08, location 1, bit 3) Bell Test
on Arm provides a single Bell chirp when arming and a double chip on disarming.
Strobe Trigger – Allows the trigger output to Pulse with the same timing as the Bell Test option
(chirp or non-chirp).
Limited Access to Programming – Prevents the installer from accessing questions 01 through
03 and 09 and 10 in keypad programming. This feature is set in the downloader only.
RF Programming Using Bypass Key – This feature, if enabled, allows access to RF
programming by pressing the [Bypass] key and the 2-digit RF question number. Otherwise the
method is to press [*] [#] and the 2-digit RF question number.
Recent Panic – If enabled in question 37, location 4, when the Panic is pressed on a keyfob
followed by an arm or disarm function within a 1-minute window, the panel sends a recent panic
code to the central station.
Exit Programming Central Station Report – This feature, if enabled, sends a code to the
central station when exiting keypad programming.