FBII Omni-408A, Installation And Setup Gude, Page: 36 / 96

OMNI-408A Installation and Setup Guide
9–2
Programming Questions - Installer Programming
This section of the manual defines the programming questions along with the values
expected for each question.
DO NOT attempt to enter data before completely filling out Appendix B: OMNI-408A System
Programming Worksheet .
QUESTION 01
PRIMARY TELEPHONE NUMBER
DEFAULT = 234AAAAAAAAAAAAA
Enter the telephone number (including area code and/or dialing prefix, if necessary) of the
primary central station receiver in L1 - L16. Enter the valid digits from the table below.
Digit FUNCTION COMMENTS
0-9 0-9 Dialing digits
A Signifies end of the phone number Enter after last digit of phone number
B
Asterisk (
✴
)
Enter whenever the asterisk is used
C 3-Second pause Provides delay to wait for dial tone
D Pound (#) Enter whenever the pound is used
E
✴
70C (TouchTone)
✴
1170C (Rotary)
Enter to disable Call Waiting
F 800 Enter whenever the “800” prefix is needed
REPORTING ROUTE:
The system reports all signals to the primary receiver phone number. If the secondary phone
number has been programmed, the panel alternates between the primary and secondary
receivers for a maximum of 8 attempts each until the signal has been acknowledged.
QUESTION 02
SECONDARY TELEPHONE NUMBER
DEFAULT = AAAAAAAAAAAAAAAA
OR PAGER FOLLOW-ME NUMBER
Using the table in question 01 to determine valid digits, enter the telephone number
(including area code and/or dialing prefix, if necessary) of the secondary central station
receiver or a Pager Follow-Me number in L1 - L16.
The secondary telephone number is used if the panel is unable to reach the central station
via the primary number. This is known as BACKUP reporting. If the SPLIT REPORTING
feature is programmed, then opening and closing signals are directed to the secondary CS
phone number only, while all other conditions are reported to the primary number.
If enabled in question 08, location 4 and question 26, location 4, the Pager Follow-Me number
is used as a pager number or forwarding (site) number where the user can receive digital
messages from the OMNI-408A that are a result of programmable events occurring on the
system.
The pager number can be programmed here or via the end user method using the [#] [5] [8] keys.