FBII Omni-408A, Installation And Setup Gude, Page: 32 / 96

OMNI-408A Installation and Setup Guide
8–2
Installer Mode 1 (System Default)
You can initiate a system default through the keypad by pressing the [1] and [3] keys at the
same time while in the Programming mode. The system will then default (revert to factory-
programmed values) and go through the reset sequence. You can also initiate a system
default by removing power (AC and DC), shorting JP1 and JP2, reapplying power (with JP1
and JP2 still intact) waiting 8 seconds, and then removing the short with power still applied.
NOTE: You can select a programming option through the EZ-Mate Downloader Software
called Default Lockout. If you select it, a system default reset will change all of the
programmable options with the exception of the CS ID (a code used by the software to
identify the panel during remote connections) and the Installer code. This prevents hostile
account takeovers.
Installer Mode 1 (User Code Default)
The user codes can be reset to factory default values (User Code 1 = 1234) by pressing the [7]
and [9] keys at the same time while in the Programming mode. The user codes will default
and the system will go through the reset sequence.
Installer Mode 1 (RF Programming)
You can enter the RF Programming mode by pressing [Bypass] XX or [*] [#] XX, where XX is
01 to 14 and selects the desired RF Programming question number. Refer to Section 10:
Programming Questions - RF Programming for specific information.
When RF Programming mode is entered, the question number LEDs will blink rapidly.
Installer Mode 3 (Unattended Download)
The Unattended Download function allows the control panel to dial the telephone number of
CS downloading computer so that the control panel can be downloaded without having the
operator present. The CS downloading computer telephone number is programmed into the
callback number (question 03) and an unattended identification number is programmed into
the secondary telephone (question 02).
NOTE: These are temporary values, as they will be reprogrammed after downloading.
Unattended Download requires the following sequence:
1. The PC operator must select UNATTENDED DOWNLOAD in the Downloader Software
Main Menu.
2. Enter Unattended Download mode: press [Code] [*] Installer Code, [3].
3. The system now enters keypad programming at question 01. Enter the telephone number
of the central station downloading computer. Enter [#] after each digit; for example:
press [1] [#] [2] [#] [3] [#]. You can enter up to 16 digits. This phone number should be the
same as the CS callback number (question 03 from Keypad Programming if the panel is
programmed for callback).
4. Go to programming question 02 by entering [*] [0] [2]. Enter the desired account number,
following each digit with [#]. This will be used by the CS downloading computer to
determine the proper account information to download to this subscriber. The account
number must be 6 digits in length. The downloader's account designator, not the account
number, will be communicated to the receiver. For ID's less than 6 digits long, you must
enter leading 0's to make the number 6 digits long. Example: For ID 345, enter [0] [#] [0]
[#] [0] [#] [3] [#] [4] [#] [5] [#].