![background image](http://html1.mh-extra.com/html/fbii/omni-408a/omni-408a_installation-and-setup-gude_547064030.webp)
OMNI-408A Installation and Setup Guide
7–2
Set Time/Date [#] [3]
The AC-based clock can be set at the keypad, but it can only be viewed by the PC downloader
software.
To set time/date: Press [#] [3] Hours, Minutes, Month, Day, Year
Where:
Hours = 2 digits (00-23)
Month = 2 digits (01-12)
Year = 2 digits (00-99)
Minutes = 2 digits (00-59)
Day = 2 digits (01-31)
Toggle Chime [#] [6]
This quick command is always enabled. If any zones are programmed with a Chime option
(see programming questions 11–18), then [#] [6] will turn the system chime on or off,
depending on its original state.
•
The Toggle Chime command toggles the Chime feature for the entire system. Because there
are no visual indications on the keypads after toggling the chime, you must be aware of its
present state.
•
The installer must enable the Chime option for any zone that requires chime.
Toggle Pager [#] [8]
This quick-command feature provides any user the ability to toggle on or off open/close
events, if the events are enabled, from tripping the pager. This feature is non-selectable. The
feature toggles an internal bit that indicates to the system if the feature is engaged or not.
There is no visual indication with this feature, only an acknowledgement tone upon pressing
[#] [8].
On-Line Download [#] [9]
If programmed (see programming question 05, location 4), the user can initiate a remote
communications session with the CS downloading computer at the control panel. Typically, a
remote communications session is initiated by the CS. On-line downloading allows the user
to call the office, discuss the action required, and allow the CS operator to complete the
request while on-line. No additional telephone call is needed. On-line connection can be made
as follows:
Stage
What Happens
1
The user dials the CS downloading modem telephone line from the premises
telephone line that the alarm system uses. Connection is made with a person at the
CS downloading computer, and the account to be downloaded is verbally identified.
The CS computer attempts to establish a connection with the site.
2
The user is instructed to enter [#] [9] on the keypad, which causes the control panel to
react as if it had received a request for a remote communications session and to look
for the standard panel to CS protocol.
3
Once the standard connection is made, the remote communications session can take
place (upload, download, and remote commands).
4
The user hangs up the telephone to prevent interference that may affect
upload/download data. The downloader software automatically terminates the
connection after remote communications end.
Summary of Contents for Omni-408A
