FAW Jilin Automobile Xenia S80, Handbook

Page: 216 / 262

14-4
4. Place a container under the drain plug
to receive the discharged engine oil.
5. Use a spanner to remove the drain plug
and gasket, and drain the oil. Wear
safety goggles when necessary.
6. Use an oil filter spanner to unscrew the oil filter, and remove it by
hand.
7. Apply a coat of engine oil onto the rubber gaskets for the new oil
filter.
8. Screw the new filter to a designated position by hand till the gasket
reaches the pedestal. Then, screw it down for 3/4 to 1 turn, and fix
the filter onto the pedestal.
9. Reinstall the drain plug and new gaskets. Tighten up the drain plug.
Tightening torque:
23.6-35.4N·m
(2.4-3.6kgfm)
25-35 N·m
(2.6-3.6kgfm)
Warning
Do not excessively tighten up the oil filter and drain plug for fear of
oil leakage.
10. Charge up the engine oil slowly.
For recommended engine oils and volumes, see Section 15.
11. Install the oil filler cap by hand.
12. Wait for a few minutes, and check the engine oil level.
13. Run the engine, and check the oil filter or drain plug for
engine oil leakage.
If any leakage is detected, the oil filter or drain plug is
improperly installed.
14. Shut down the engine and wait for several minutes.
Check the engine oil level once more, and add oil when
necessary.