Evidence Cross-8/HPoE-10G, User Manual

Page: 62 / 321

 TCP / UDP Port Number :
The TCP/UDP port number can be used to calculate the destination port for the frame.
Check to enable the use of the TCP/UDP Port Number, or uncheck to disable. By default,
TCP/UDP Port Number is enabled.
Aggregation Group Configuration

Group ID :
Indicates the group ID for the settings contained in the same row. Group ID "Normal"
indicates there is no aggregation. Only one group ID is valid per port.

Port Members :
Each switch port is listed for each group ID. Select a radio button to include a port in an
aggregation, or clear the radio button to remove the port from the aggregation. By default,
no ports belong to any aggregation group. Only full duplex ports can join an aggregation
and ports must be in the same speed in each group.
Buttons

Apply :
Click to save changes.

Reset :
Click to undo any changes made locally and revert to previously saved values.
3-5.2 LACP Configuration
This page allows the user to inspect the current LACP port configurations, and possibly
change them as well.
Web Interface
To configure the LACP Port Configuration in the web interface:
1. Click Port Management, Link Aggregation and LACP Configuration.
2. Evoke to enable or disable the LACP on the port of the switch.
3. Scroll the Key parameter with Auto or Specific. Default is Auto.
4. Scroll the Role with Active or Passive. Default is Active.
5. Click Apply to save the setting.
6. If you want to cancel the setting then you need to click the reset button. It will revert to
previously saved values.
Figure 3-5.2: The Lacp Configuration