Evidence Cross-8/HPoE-10G, User Manual

Page: 20 / 321

Web Interface
To configure an Advanced Settings in the web interface:
1.
Click System, IP Address and Advanced Settings.
2. Click Add Interface then you can create new Interface on the switch.
3. Click Add Route then you can create new Route on the switch.
4. Click Apply.
Figure 2-2.2: The advanced IP settings
Parameter description:
Basic Setting

Mode :
Configure whether the IP stack should act as a Host or a Router. In Host mode, IP traffic
between interfaces will not be routed. In Router mode traffic is routed between all
interfaces.
 DNS Server :
This setting controls the DNS name resolution done by the switch.
There are four servers available for configuration, and the index of the server presents the
preference (less index has higher priority) in doing DNS name resolution.
The following modes are supported:

No DNS server
No DNS server will be used.

Configured IPv4
Explicitly provide the valid IPv4 unicast address of the DNS Server in
dotted decimal
notation .
Make sure the configured DNS server could be reachable (e.g. via PING) for activating
DNS service.

Configured IPv6
Explicitly provide the valid IPv6 unicast (except linklocal) address of the DNS Server.
Make sure the configured DNS server could be reachable (e.g. via PING6) for activating