Evidence Cross-8/HPoE-10G, User Manual

Page: 19 / 321


Gateway :
The IP address of the IP gateway. Valid format is dotted decimal notation or a valid IPv6
notation. Gateway and Network must be of the same type.

DNS Server :
This setting controls the DNS name resolution done by the switch.
There are four servers available for configuration, and the index of the server presents the
preference (less index has higher priority) in doing DNS name resolution.
The following modes are supported:

No DNS server
No DNS server will be used.

Configured IPv4
Explicitly provide the valid IPv4 unicast address of the DNS Server in
dotted decimal
notation .
Make sure the configured DNS server could be reachable (e.g. via PING) for activating
DNS service.

Configured IPv6
Explicitly provide the valid IPv6 unicast (except linklocal) address of the DNS Server.
Make sure the configured DNS server could be reachable (e.g. via PING6) for activating
DNS service.

From any DHCPv4 interfaces
The first DNS server offered from a DHCPv4 lease to a DHCPv4-enabled interface will be
used.

From this DHCPv4 interface
Specify from which DHCPv4-enabled interface a provided DNS server should be
preferred.

From any DHCPv6 interfaces
The first DNS server offered from a DHCPv6 lease to a DHCPv6-enabled interface will be
used.

From this DHCPv6 interface
Specify from which DHCPv6-enabled interface a provided DNS server should be
preferred.
Buttons

Apply :
Click to save changes.
2-2.2 Advanced Settings
Configure the switch-managed IP information on this page
Configure IP basic settings, control IP interfaces and IP routes.
The maximum number of interfaces supported is 128 and the maximum number of routes is
128.