Evidence Cross-8/HPoE-10G, User Manual

Page: 51 / 321

no longer exists. Due to the unreliable nature of UDP, in the standard it is recommended
that such refreshing of advertisements to be done at less than one-half of the advertising
duration. In the implementation, the switch sends SSDP messages periodically at the
interval one-half of the advertising duration minus 30 seconds. Valid values are in the range
100 to 86400.

IP Addressing Mode
IP addressing mode provides two ways to determine IP address assignment:
Dynamic : Default selection for UPnP. UPnP module helps users choosing the IP address of
the switch device. It finds the first available system IP address.
Static : User specifies the IP interface VLAN for choosing the IP address of the switch device.

Static VLAN Interface ID
The index of the specific IP VLAN interface. It will only be applied when IP Addressing
Mode is static. Valid configurable values ranges from 1 to 4095. Default value is 1.
Buttons

Apply :
Click to save changes.
 Reset :
Click to undo any changes made locally and revert to previously saved values.
Chapter 3 Port Management
The section describes to configure the Port detail parameters of the switch. Others you could
use the Port configure to enable or disable the Port of the switch. Monitor the ports content
or status in the function.
3-1 Port Configuration
This page displays current port configurations. Ports can also be configured here.
Web Interface
To configure a Current Port Configuration in the web interface:
1. Click Port Management and Port Configuration.
2. Specify the detail Port alias or description an alphanumeric string describing the full name
and version identification for the system’s hardware type, software version, and
networking application.
3. Specify the Speed Configured, Flow Control, Maximum Frame Size.
4. Click Apply.