Maintenance 12. Recovering the HDD
(5) After “SKIP BAD SECTOR CHECK [Y, N]” appears, press the <Y> or the <N> key.
The time required will change by the key selection since the process changes. The
required is only a measure.
)
NOTE
Key Contents
Time
Required
Y
Skip the bad sector check
About 3 minutes
N
Do not skip the bad sector check
About 20 minutes
)
NOTE
For the recovery of the HDD that has been used in the RC420, selecting “N” is
recommended.
(6) Terms of use appears. Follow the procedure and press the <Enter> key three times.
(7) Easy Restore starts.
(8) Click the <Continue> button.
If you click the <Cancel> button, the Easy Restore ends. When you accidentally
turned ON the RC420 with the recovery disk in the FD drive, click the <Cancel>
button in this window.
)
NOTE
RC420 Rev.9
145
Summary of Contents for RC420
