Endress+Hauser Liquiline System CA80HA, Operating Instructions Manual

Page: 75 / 214

Liquiline System CA80HA Operation
Hauser 75
Menu/Setup/General settings/Extended setup/Ethernet
Function Options Info
Enable Selection
• Off
• On
Factory setting
On
You can switch off communication at this
point. The software can then only be accessed
via local operation.
Settings
Link settings Selection
• Auto negotiation
• 10MBps Half duplex
• 10MBps Full duplex
• 100MBps Half duplex
• 100MBps Full duplex
Factory setting
Auto negotiation
Transmission methods of the communication
channels
• Full duplex:
Data can be transmitted and received
simultaneously.
• Half-duplex:
Data can be transmitted and received on an
alternating basis only, i.e. not
simultaneously.
DHCP Selection
• Off
• On
Factory setting
On
The Dynamic Host Configuration Protocol
(DHCP) makes it possible to assign the network
configuration to clients via a server. With
DHCP, it is possible to automatically integrate
the device into an existing network without the
need for manual configuration. Normally only
the automatic assignment of the IP address
must be configured at the client. During
startup, the IP address, the netmask and the
gateway are retrieved from a DHCP server.

Do you want to assign the IP address of
the device manually? If so, you have to
set
DHCP = Off .
IP-Address xxx.xxx.xxx.xxx An IP address is an address in computer
networks which are based on the Internet
protocol (IP).
You can only set the IP address if
DHCP is
switched off.
Netmask xxx.xxx.xxx.xxx On the basis of the IP address of a device, the
netmask specifies which IP addresses this
device searches for in its own network and
which addresses it could access in other
networks via a router. It therefore divides the
IP address into a network part (network prefix)
and a device part. The network part must be
identical for all devices in the individual
network, and the device part must be different
for every device within the network.
Gateway x.x.x.x A gateway (protocol converter) enables
communication between networks that are
based on completely different protocols.
Service switch Read only