Digitus DN-80233, User Manual

Page: 95 / 379

94
Session ID
It is an integer value used to identify the session. Its value can be anything
between 1 and L7_MIRRORING_MAX_SESSIONS.
Monitor Session Mode
It indicates whether the Port Mirroring feature is enabled or disabled for
the session identified with <session-id>. The possible values are Enabled
and Disabled.
Probe Port
It is the probe port (destination port) for the session identified with <session-
id>. If probe port is not set then this field is blank.
List of source Ports
It is the list of ports, which are configured as mirrored ports (source ports)
for the session identified with <session-id>. If no source port is configured
for the session then this field is blank.
7.5.29 show port
This command displays port information.
Format
show port {<unit/slot/port> | all}
Mode
Privileged EXEC
Unit/Slot/Port
Valid unit, slot and port number separated by forward slashes.
Type
If not blank, this field indicates that this port is a special type of port. The possible values
are:
Mon
- this port is a monitoring port. Look at the Port Monitoring screens to find out more
information.
Lag
- this port is a member of a port-channel (LAG).
Probe
- this port is a probe port.
Admin Mode
Selects the Port control administration state. The port must be
enabled in order for it to be allowed into the network. - May be enabled or
disabled. The factory default is enabled.
Physical Mode
Selects the desired port speed and duplex mode. If
auto-negotiation support is selected, then the duplex mode and speed will be set
from the auto-negotiation process. Note that the port's maximum capability (full
duplex -100M) will be advertised. Otherwise, this object will determine the port's
duplex mode and transmission rate. The factory default is Auto.
Physical Status
Indicates the port speed and duplex mode.
Link Status
Indicates whether the Link is up or down.
Link Trap
This object determines whether or not to send a trap when link status changes. The
factory default is enabled.