Digitus DN-80233, User Manual

Page: 233 / 379

232
markdscp.
Non-Conform IP Precedence Value This field displays the IP Precedence mark value if this
action is markprec.
Non-Conform Secondary COS
The action to be taken on violating packets conforming with
the secondary class of service per the policing metric.
Peak Burst Size (KB)
This field displays the peak burst size, used in two-rate policing.
Peak Rate (Kbps)
This field displays the peak rate, used in two-rate policing.
Policing Style
This field denotes the style of policing, if any, used (simple, single rate, or two
rate).
Redirect
Forces a classified traffic stream to a specified egress port (physical or LAG). This
can occur in addition to any marking or policing action. It may also be specified along with a
QoS queue assignment.
If the Policy Name is not specified this command displays a list of all defined DiffServ policies.
The following fields are displayed:
Policy Name
The name of this policy. (Note that the order in which the policies are
displayed is not necessarily the same order in which they were created.)
Policy Type
The policy type, namely whether it is an inbound or outbound policy definition.
Class Members
List of all class names associated with this policy.
9.7.4 show diffserv service
This command displays policy service information for the specified interface and direction. The
<
unit/ slot/port
>
parameter specifies a valid unit/slot/port number for the system. The direction
parameter indicates the interface direction of interest.
Format
show diffserv service
<
unit/slot/port> {in}
Mode
Privileged EXEC
DiffServ Admin Mode
The current setting of the DiffServ administrative mode. An attached policy
is only in effect on an interface while DiffServ is in an enabled mode.
Interface
Valid unit, slot and port number separated by forward slashes.
Direction
The traffic direction of this interface service.
Operational Status
The current operational status of this DiffServ service interface.
Policy Name
The name of the policy attached to the interface in the indicated direction.
Policy Details
Attached policy details, whose content is identical to that described for the show
pol icy-map <policymapname> command (content not repeated here for brevity).
9.7.5 show diffserv service brief
This command displays all interfaces in the system to which a DiffServ policy has been attached.
The direction parameter is optional; if specified, only services in the indicated direction are shown,
otherwise service information is shown for both directions, where applicable.
Format show diffserv service brief {in}
Mode
Privileged EXEC
DiffServ Mode
The current setting of the DiffServ administrative mode. An attached policy is only active