Digitus DN-80233, User Manual

Page: 321 / 379

320
12.1.55 neighbor <peeripaddr> timers <keepalive> <holdtime>
This command specifies the keep alive and hold time for a peer. This value is placed in an OPEN
message sent to this peer by this BGP speaker. The possible values for keep alive field are 0 to
21845 seconds and for hold time field are 0 and 3 to 65535 seconds. After executing this
command, the BGP peer must be reset before the changes will take affect
Default
holdtime seconds
Default
keepalive 90 seconds
Format neighbor <peeripaddr> timers <keepalive> <holdtime>
Mode Router BGP Config
12.1.55.1 no neighbor <peeripaddr> timers
This command specifies the default keep alive and hold time for a peer. After executing this
command, the BGP peer must be reset before the changes will take affect
Format no neighbor <peeripaddr> timers
Mode Router BGP Config
12.1.56 neighbor <peeripaddr> txdelayint
This command configures the delay interval between two transmission sessions of MsgSendLimit
packets. The range for this field is 1 to 5
.
Default
none
Format neighbor <peeripaddr> txdelayint <1-5>
Mode Router BGP Config
12.1.56.1 no neighbor <peeripaddr> txdelayint
This command configures the default delay interval between two transmission sessions of
MsgSendLimit packets.
Format no neighbor <peeripaddr> txdelayint
Mode Router BGP Config
12.1.57 network
This command adds NLRI (Network Layer Reachability Information) to the BGP4 Router. The NLRI
field contains a list of network numbers being advertised. The network number is a valid IP
address entry. The [send | donotsend] field indicates whether or not this prefix should be sent. The
<vpncos> field allows assignment of the VPN/COS identifier. A maximum of 10 NLRIs can be
added.