Digitus DN-80233, User Manual

Page: 106 / 379

105
7.6.23 show vlan port
This command displays VLAN port information.
Format
show vlan port {<unit/slot/port> | all}
Modes
Privileged EXEC
User EXEC
Unit/Slot/Port
Valid unit, slot and port number separated by forward slashes. It is possible to
set the parameters for all ports by using the selectors on the top line.
Port VLAN ID
The VLAN ID that this port will assign to untagged frames or priority tagged
frames received on this port. The value must be for an existing VLAN. The factory default is 1.
Acceptable Frame Types
Specifies the types of frames that may be received on this port. The
options are 'VLAN only' and 'Admit All'. When set to 'VLAN only', untagged frames or priority
tagged frames received on this port are discarded. When set to 'Admit All', untagged frames or
priority tagged frames received on this port are accepted and assigned the value of the Port VLAN
ID for this port. With either option, VLAN tagged frames are forwarded in accordance to the 802.1Q
VLAN specification.
Ingress Filtering
May be enabled or disabled. When enabled, the frame is discarded if this port
is not a member of the VLAN with which this frame is associated. In a tagged frame, the VLAN is
identified by the VLAN ID in the tag. In an untagged frame, the VLAN is the Port VLAN ID specified
for the port that received this frame. When disabled, all frames are forwarded in accordance with
the 802.1Q VLAN bridge specification. The factory default is disabled.
GVRP
May
be enabled or disabled.
Default Priority
The 802.1p priority assigned to tagged packets arriving on the port.
7.6.24 vtrunk set
This command configures port as trunk port, the port is included into the all VLAN’s that are
mentioned in <vlan-list>, and traffic will be transmitted as tagged. The syntax of the <vlan-list> is
separate non-consecutive VLAN IDs with a comma and no spaces; use a hyphen to designate a
range of IDs.
Format
vtrunk set {<vlan-list>}
Modes
Interface config
<vlan-list>
The syntax of the <vlan-list> is separate non-consecutive VLAN IDs with a comma
and no spaces; use a hyphen to designate a range of IDs. For example, you may set “vtrunk set
1,2,5-8”.
7.6.25 vtrunk clear
This command remove the vlan id specified in <vlan-list> from this interface.
Format
vtrunk clear {<vlan-list>}
Modes
Interface config
<vlan-list>
The syntax of the <vlan-list> is separate non-consecutive VLAN IDs with a comma