DigiDesign D-Show Profile, Manual

Page: 92 / 270

D-Show Profile Guide 82
Adjusting Group Bus Output Controls
Group Bus Output Levels
See “Adjusting Output Controls” on page 74.
Group Bus Output Pan
Group bus output pan is controlled from the Output encod-
ers.
Groups-to-Mains assignment is displayed by the indicator
LED for each Output encoder, when Groups are banked to the
Output faders. The Output encoder Pan switch cycles the en-
coders and LCD to pan, balance and width parameters.
The pan controls adjust pan (when in mono Groups configu-
ration) or stereo balance and width (when in stereo Groups
configuration) of the Group output to the Main busses only.
The Group outputs in the Patchbay are distinct left and right
channels.
To control mono Group output pan:
1
Bank the Output faders to Groups.
2
Press the Pan switch in the Output encoder section once to
assign control of Group pan to the Output encoders.
3
Turn a rotary encoder to adjust the pan for the correspond-
ing mono Group.
To control stereo Group output balance and width:
1
Press the Pan switch in the Output encoder section.
2
Turn a rotary encoder to adjust the balance for the corre-
sponding stereo Group.
3
Press the Group Pan switch in the Output Encoder assign-
ment section an additional time to assign Group width con-
trol to the Output encoders.
4
Turn a rotary encoder to adjust the width for the corre-
sponding stereo Group.
Group Bus Output Polarity (Phase) Invert
See “Output Polarity (Phase) Invert” on page 74.
Group Bus Output Solo
See “Output Solo” on page 74.
Group Bus Output Mute
See “Output Mute” on page 74.
Simple and Expert Operational Modes
When configuring Group busses, you can choose between two
operational modes that provide different levels of flexibility:
Simple mode and Expert mode .
Setting the Operational Mode
To switch between Simple mode and Expert mode:
1
Put D-Show into Config mode.
2
Go to the Options page and click the Busses tab.
3
Under Stereo Group Panning Operation, select the mode
you want to use (Simple or Expert).
Working with Mono Group Busses
When configured as mono busses, Groups can operate in the
following modes:
Simple Mode
In Simple mode, either all Groups on a channel are mono, or
all Groups on a channel act as bus pairs.
Expert Mode
In Expert mode, any of the 4 bus pairs can be stereo linked in-
dividually while leaving the other busses as mono, on a per
channel basis.
To set the link status of individual mono Group busses on a
channel (Expert Mode only):
1
Make sure Stereo Group Panning is set to Expert Mode.
2
Select an Input Channel or FX Return whose signal you
want to send to a Group bus. To select multiple channels, use
the Multi-Select switch next to the input faders.
3
In the ACS Bus Assigns section, press the Stereo Pan switch.
The switch flashes yellow to indicate bus link mode.
4
Press any of the Group switches to link or unlink the bus
pairs (1–2, 3–4, 5–6, or 7–8). The Group switch pairs flash yel-
low to indicate stereo linked, or flash green to indicate mono.
5
Press the flashing Stereo Pan switch to confirm the bus link
status for the selected channels.
Setting the Group bus operational mode