DigiDesign D-Show Profile, Manual

Page: 56 / 270

D-Show Profile Guide 46
Output Channels
The following Output channel parameters
are not copied or pasted (the current settings of the destina-
tion channels are retained):
• Patchbay assignments, including Direct Outs
• Channel Name
• Hardware and software insert (plug-in) assignments and
in/out status
• GEQ settings
• Output membership (the assignment of channels to an
Aux, Group VCA, Matrix or PQ).
Make Selected Mono Strips Stereo/Make Selected
Stereo Strip Mono
Combines two selected mono channels into a single stereo
channel, or splits a selected stereo channel into two mono
channels. D-Show must be in Config mode to change the ste-
reo status of a channel.
Move Selected Strip
Moves a selected strip from its current position to a new loca-
tion. When you move a channel strip, other channels are
moved (and renumbered) lower or higher to accommodate
the moved channel.
D-Show must be in Config mode to move channel strips.
To move a fader strip:
1
Put D-Show in Config mode.
2
Select the channel you want to move.
3
On-screen, right-click on the destination strip (where you
want to move the selected channel).
4
Choose Move Selected Strip Here from the pop-up menu.
Channel Control Shortcuts
The on-screen channel faders and encoders provide the fol-
lowing right-click shortcuts to reset individual parameters and
channel strips.
Reset Parameter
To reset an on-screen fader or encoder to its default value, do one
of the following:
■
Right-click the control and choose Reset.
– or –
■
Alt-click the control.
Reset Channel
To reset an entire channel strip to its default settings:
■
Right-click the on-screen channel fader and choose Reset
Strip.
Input Channel Presets
Input channel configuration (input name, gain, fader levels,
send levels and bus routing) can be stored and recalled as In-
put Channel Presets. Input Channel Presets can be previewed,
recalled and transferred just like other D-Show preset files, let-
ting you quickly configure channels from among a library of
favorite setups.
When an Input Channel is stored or recalled as a preset, all pa-
rameters are affected except the following:
• Patchbay assignments, including Direct Outs
• Hardware and software insert (plug-in) assignments and
in/out state.
To copy GEQ settings, use the copy/paste GEQ shortcut or
use GEQ Presets. Use the Replace with Mix (members) From
command to replace output membership for an Aux,
Group, VCA, Matrix or PQ.
Snapshots cannot store and recall custom console channel
position.
Right-clicking channel strip controls on-screen