10
EXPERT 64EU rev.03
2. MOUNTING INSTRUCTIONS
2.1
Installing the Controller on the Wall
Fasten the four metal brackets on the mounting holes located behind the controller
using the four screws included with the controller. Mount the enclosure on the wall
using four other screws. Be sure the electrical knockouts are at the bottom of the
enclosure in order to prevent water from entering the controller. The enclosure must
be mounted in a location that will allow the cover to be completely opened right up
against the wall.
2.2
Connections
Note that the input connectors are now removable. This
makes it easier to connect the different elements to the
terminals.
2.2.1 Controller’s Main Wiring
Refer to the wiring diagram enclosed with this user's manual to connect the control-
ler. Use the electrical knockouts provided at the bottom of the enclosure. Do not
make additional holes in the enclosure, particularly on the side of the enclosure when
using a computer communication module.
ALL WIRING MUST BE DONE BY AN AUTHORIZED ELECTRICIAN
AND MUST COMPLY WITH APPLICABLE CODES, LAWS AND
REGULATIONS. MAKE SURE POWER IS OFF BEFORE DOING ANY
WIRING TO AVOID ELECTRICAL SHOCKS AND EQUIPMENT DAM-
AGE.
2.2.2 Probe Inputs
Probes operate at low voltage and are isolated from the supply. Make sure that probe
cables remain isolated from all high voltage sources. In particular, do not route the
probe cables through the same electrical knockout as other cables. Do not connect
the shield from the probe cable to a terminal or a ground.
:$51,1*
Summary of Contents for Integra EXPERT 64EU
