3D
AEC Calibration
CPI Canada Inc.
Use and disclosure is subject to the restrictions on the title page of this CPI document.
Page 3D-4
Rev. A CMP 200
®
Service Manual Ch # 901476-05
3D.2.1 AEC Board (Solid State Chambers) Cont
Tables 3D-1 and 3D-2 show the pin outs for both the 6 pin circular connectors and for the 7 pin in-line
connectors on the AEC board in figure 3D-1.
FUNCTION PIN
Anode, right (refer to note below)
3
Cathode, right (refer to note below)
4
Anode, middle
1
Cathode, middle
6
Anode, left (refer to note below)
2
Cathode, left (refer to note below)
5
Ground Connector
shell
Table 3D-1: Pin outs for 6 pin circular connector J1 to J4
FUNCTION PIN
Anode, right (refer to note below)
1
Cathode, right (refer to note below)
2
Anode, middle
3
Cathode, middle
4
Anode, left (refer to note below)
5
Cathode, left (refer to note below)
6
Ground 7
Table 3D-2: Pin outs for 7 pin in-line connector J11 to J14
NOTE:
Jumpers JW1 to JW8 swap the left and right fields from J1 to J4 and J11 to J14 as per the table below.
CHANNEL
LEFT / RIGHT FIELDS AS PER
TABLES 3D-1, 3D-2
LEFT / RIGHT FIELDS SWAPPED RELATIVE
TO TABLES 3D-1, 3D-2
1
Jumper JW1, JW2 pins 1-2 (N)
Jumper JW1, JW2 pins 2-3 (R)
2
Jumper JW3, JW4 pins 1-2 (N)
Jumper JW3, JW4 pins 2-3 (R)
3
Jumper JW5, JW6 pins 1-2 (N)
Jumper JW5, JW6 pins 2-3 (R)
4
Jumper JW7, JW8 pins 1-2 (N)
Jumper JW7, JW8 pins 2-3 (R)
