![background image](http://html1.mh-extra.com/html/cpi/cmp-200/cmp-200_service-manual_2675020174.webp)
CPI Canada Inc.
Interfacing and Programming
3C
Use and disclosure is subject to the restrictions on the title page of this CPI document.
CMP 200
®
X-Ray Generator Service Manual Ch # 901476-04 Rev. C
Page 3C-105
3C.13.6 Touchscreen Setup (Cont)
Step Action
8.
Press
OK
to continue;
CANCEL
cancels the changes.
9.
A pop-up window will display asking if you wish to save the changes. Press
YES
to save the changes. Press
NO
to return to the
system utilities menu;
CANCEL
cancels the changes.
3C.13.7 Touchscreen
Calibration
The touchscreen calibration function should be performed if touching the center of a buttons does not activate that function, i.e. if the touch-
sensitive area appears displaced from the center of the corresponding icon.
Use these steps to perform the touchscreen calibration.
Step Action
1.
From the system utilities menu, press
Touch Screen Calibration
.
2.
A white screen with a cross-hairs target will appear in the top left corner of the display.
3.
Press the center of the target at the top left of the screen. This will set up the touch sensitive area in that quadrant.
4.
Repeat the previous step for the four remaining targets.
5.
Another white screen will appear with an
X
enclosed by a box in the top left corner and a 10 second timer in the center of the
display.
6.
Press the center of the target at the top left of the screen. This will verify the touch sensitive area in that quadrant.
7.
Repeat the previous step for the four remaining targets.
8.
If the calibration procedure was done properly you will be taken to the
System Utilities
menu.
•
If the calibration procedure was not done properly the calibration sequence will restart from the beginning allowing you to
redo the touchscreen calibration.
NOTE:
IF THE TOUCHSCREEN CALIBRATION IS OUT SIGNIFICANTLY, CONNECT A USB (PC) KEYBOARD TO ONE OF THE USBA
PORTS ON THE REAR OF THE TOUCHSCREEN CONSOLE, POWER UP THE UNIT AND WHEN THE MAIN MENU IS
DISPLAYED PRESS ALT-C TO INITIATE THE CALIBRATION PROCEDURE. FOLLOW THE STEPS ON THE PREVIOUS PAGE
TO COMPLETE THE TOUCHSCREEN CALIBRATION.
CPI RECOMMENDS NO OTHER BUTTONS BE PRESSED ON THE USB KEYBOARD AS THIS MAY INADVERTENTLY CAUSE
CORRUPTION OF THE TOUCHSCREEN SOFTWARE.