Covidien Newport e360, Service Manual

Page: 72 / 154

Component Removal and Replacement
4-12 Service Manual
To replace the LCD cable, refer to Figure 4.10 and perform the following steps:
1.
Remove the display board by performing the procedure in section 4.9 .
2.
Using a 7/32 inch nut driver, remove the nut securing the ground wire of GR-CBL2155A to the LCD
housing BKT2104M.
3.
Using a 7/32 inch nut driver, remove the nut securing the cable restraint for GR-CBL2155A to the LCD
housing BKT2104M.
4.
Gently lift the cable away from the LCD housing, releasing it from the double-sided tape.
5.
Pull cable GR-CBL2155A away from connector CN1 on the rear of the LCD display.
6.
To reinstall the LCD cable, perform the following steps:
a.
Carefully align the cable connector with CN1 on the LCD display.
b.
Bend the cable up.
c.
Push the connector onto CN1.
d.
Press the connector onto the double-sided tape.
e.
Reverse steps 2 and 3.
4.11.2
LCD Display (10139301)
To replace the LCD display, refer to Figure 4-8. and Figure 4-9. , and perform the following steps:
1.
Remove the LCD cable by performing the procedure in section 4.11.1 , “ Large LCD Cable (GR-CBL2155A) .”
2.
Remove the four nuts and washers securing the LCD housing (BKT2104M) to the CVR2104M.
3.
Remove the four screws securing the BKT2104M to the LCD display (10139301).
4.
Reinstall the LCD display by reversing steps 2 and 3.