Covidien Newport e360, Service Manual

Page: 73 / 154

Front Panel Cover (CVR2104M)
Service Manual 4-13
4.12
Front Panel Cover (CVR2104M)
Figure 4-9. Front Panel Cover (CVR2104M)
To remove and reinstall the front panel cover, refer to Figure 4-9. and perform the following steps:
1.
Remove the display board by performing the procedure in section 4.9 , “ Display Board (GR-PCB2109A) .”
2.
Using a 51/64 inch hex key, remove the set screw securing the adjustment knob to the encoder.
3.
Remove the adjustment knob.
4.
Remove the eight screws and washers securing the CVR2104M to the front panel bezel (BZL2108M).
5.
Remove the nut securing the flat ribbon ground cable to the side of the front panel cover (CVR2104M).
6.
Pull the front panel cover away from the front bezel and place in an ESD-safe container.
7.
Reinstall the front panel cover by reversing steps 2 through 6.
1 Screw (one of eight securing cover) 4 BZL2108M
2 Nut securing flat ribbon ground cable 5 Adjustment knob located on front panel
3 CVR2104M 6 Backlight inverter PCB