![background image](http://html1.mh-extra.com/html/covidien/newport-e360/newport-e360_service-manual_2673907039.webp)
Overhaul Procedures
Service Manual
2-15
2.8.2
Air and Oxygen Inlet Regulator Rebuild
To remove and install the air and oxygen inlet regulator, follow the procedure in section
“
Regulators, Inlet Blocks, and Flow Sensor Block
.”
Figure 2-12.
Inlet Regulator Rebuild
Note:
Inlet regulators must be outside of the ventilator for disassembly and reassembly.
To install the air and oxygen inlet regulators rebuild kits, refer to
and perform the
following steps:
1.
Unscrew the brass cover from the regulator (no tool should be needed).
2.
Remove the spring, diaphragm, diaphragm washer, seat with o-ring, small spring, and ball.
3.
Using the parts from the regulator rebuild kit (RRK1800M), replace the used parts by reversing the
disassembly.
1
Cover
4
Diaphragm
2
Slip ring
5
O-ring
3
Spring
Summary of Contents for Newport e360
