Covidien Newport e360, Service Manual

Page: 54 / 154

Maintenance, Overhaul, and Software Upgrade
2-30 Service Manual
17.
While the numbers are flashing, rotate the adjustment knob to change the altitude level as appropriate
(for example, if located at sea level, set altitude to “0 m / 0 ft”).
18.
To confirm the selection, press Accept .
19.
Wait 15 seconds to 20 seconds.
20.
Turn the ventilator off.
21.
To access the Software Download / Diagnostics Mode screen, press and hold the Accept button, and then
turn on the ventilator.
22.
Release the Accept button once the ventilator sounds a short beep.
23.
Touch the Start Diagnostics button on the screen.The Diagnostic Data screen will appear, as shown in
Figure 2-27.
Figure 2-27. Diagnostic Data Screen
24.
Press the Trig Button on the control panel.
25.
Rotate the adjustment knob to change the value in the display window to “d9.”
26.
Press Accept .
27.
Occlude the breathing circuit from the y-piece using a cap (do not use test lung).
28.
To start the exhalation flow sensor calibration (d9), press the Manual Inflation button.
29.
Wait for 30 seconds to 1 minute until the “TSI Air flow:” and “Exhale Flow:“ numbers start to increase
gradually and the air flow is delivered from the ventilator. The exhalation flow sensor calibration
requires 6 minutes to 10 minutes to complete (see
Figure 2-27. ).
30.
When the flow delivered from the ventilator stops and ”Test Completed” appears on the screen, the
exhalation flow sensor calibration is successfully completed (see
Figure 2-27. ).
31.
Turn the ventilator off.