Covidien Newport e360, Service Manual

Page: 80 / 154

Component Removal and Replacement
4-20 Service Manual
4.16.3
Regulators, Inlet Blocks, and Flow Sensor Block
Figure 4-15. Pneumatics Panel Assembly

Note:
To replace the regulators, inlet blocks, or the flow sensor block, all screws securing the pneumatic assembly to
the back plate must be removed.
To replace the regulators, inlet blocks, and the flow sensor block, refer to Figure 4-15. and perform
the following steps:
1.
Remove the pneumatic panel assembly by performing the procedure in section 4.16 , “ Pneumatics Panel
Assembly and Components .”
2.
Remove the four screws (two per inlet block) securing the air and oxygen inlet blocks to PNL2102M.
3.
Remove the eight screws (four per valve) securing the air and oxygen PSOL valves to PNL2102M.
1 Inlet regulator (REG1800P) 4 PSOL valves
2 Inlet block (BLK2115M) 5 Back panel (PNL2102M)
3 Flow sensor block (BLK2101M)