Cognex In-Sight 1721, User Manual

Page: 64 / 156

Section 6: System Settings In-Sight
®
1700 Series Wafer Reader
54
6.2 Version Information
The Info tab shows important information about your wafer reader and its current
firmware and applet version. This information is needed if assistance is ever required
from Cognex Technical Support. The Online checkbox at the top-right of the Run tab
switches the wafer reader between its Online and Offline modes of operation. For more
information about the Online checkbox, see Section 5.1.1. The Back hyperlink, located
below the Online checkbox, returns you to the Run tab.
Figure 6-1: Info Tab
6.3 Configuring Network Settings
The Network tab (Figure 6-2) configures an In-Sight wafer reader to be used on a
network.
Figure 6-2: Network Tab
Use DHCP Server
The Use DHCP Server checkbox determines whether the wafer reader uses DHCP
(Dynamic Host Configuration Protocol) on start up or if the values in the Network tab
configure TCP/IP.
NOTE This box should be checked only if a DHCP server is running on the local network. If the box is
checked and a DHCP server does not respond within 60 seconds, the wafer reader will boot
without network support enabled.