Cognex In-Sight 1721, User Manual

Page: 132 / 156

Updating the Wafer Reader’s Firmware In-Sight
®
1700 Series Wafer Reader
122
Install Files to the Wafer Reader Flash Memory
After the wafer reader’s firmware has been updated, the .HTM, .JAR, WafID00.JOB and
.SET files included in the installation package must be copied to the wafer reader’s flash
memory before it can be accessed using a web browser. The required files can be copied
into flash using a web browser or a command prompt. The files are copied to the sensor
using an FTP session from a remote host on your network.
NOTE A WAFID00BC.job file is also included in the installation package. This job file is identical to the
default WAFID00.JOB, except the default mark type is BC 412.
To Copy Required Files Using Microsoft Internet Explorer:
NOTE New wafer readers are shipped with a User List containing three standard accounts: admin,
monitor and operator; each of these accounts is configured with a blank password.
1 Open the web browser.
2 Type
ftp://
, followed by the wafer reader’s IP address or Host Name, into the web
browser's Address bar (for example, ftp://192.68.0.1 or ftp://is1721_00060b). A Login
As dialog appears (Figure A-1).
Figure A-1: FTP Login Dialog
3 Enter the In-Sight User Name. For example, the default In-Sight User Name is admin.
4 Enter the In-Sight Password. If the wafer reader has not been assigned a new User
Name and Password, leave the Password field empty.