Cognex In-Sight 1721, User Manual

Page: 15 / 156

2 Installing the Wafer Reader
In this section…
2.1 Connecting the In-Sight Wafer Reader......................................................................6
2.2 Configuring the Internet Browser...............................................................................7
2.3 Installing the In-Sight Software ................................................................................10
2.4 Adding the Wafer Reader to the Network................................................................11
2.5 Logging On to the In-Sight Wafer Reader ...............................................................14
2.6 Communicating with the In-Sight Wafer Reader Over a Telnet Client ....................17
2.1 Connecting the In-Sight Wafer Reader
This section describes the connection of the wafer reader to its standard components. To
connect the sensor to the optional 1350 Breakout Module, refer to Appendix C:
Connecting the Breakout Module. For a complete list of options and accessories, contact
your Cognex sales representative.
2.1.1 Connecting the In-Sight 1721/1722 Wafer Reader
The wafer reader has two RJ-45 connector ports: the Network Port and the Breakout Port
(see Figure 2-1). The Network Port provides the Ethernet connection for network
communications. The Breakout Port supplies connections for the 24VDC power source,
I/O, acquisition trigger, and serial communications.
Figure 2-1: Location of RJ-45 Ports
5