Cognex In-Sight 1721, User Manual

Page: 7 / 156

In-Sight
®
1700 Series Wafer Reader
Precautions
Observe these precautions when installing the In-Sight wafer reader to reduce the risk of
injury or equipment damage:
The wafer reader is intended to be supplied by a Cognex power source (24V ±10%).
Any other voltage creates a risk of fire or shock and can damage the In-Sight
hardware.
Do not install the wafer reader in locations that directly expose it to environmental
hazards such as excessive heat, dust, moisture, humidity, impact, vibration, corrosive
substances, flammable substances, or static electricity.
To reduce the risk of damage or malfunction due to over-voltage, line noise,
electrostatic discharge (ESD), power surges, or other irregularities in the power
supply, route all cables and wires away from high-voltage power sources.
Although the wafer reader is a Class 1 LED Product, it is not recommended to stare
directly into the illumination LEDs when the wafer reader is receiving power. Note
that the In-Sight 1722 wafer reader LEDs emit infrared light, therefore the illumination
LED lights are not visible.
Do not open the wafer reader. This device does not contain user-serviceable parts.
Do not make electrical or mechanical modifications to the In-Sight hardware. The
LED emitted light levels have not been tested when the wafer reader is open,
therefore Class 1 LED Product certification is not guaranteed if the wafer reader is
open. Unauthorized modifications violate your warranty.
v