Chopin Mixolab, Maintenance Manual

Page: 84 / 144

84 Chapter 3 Repair
Maintenance manual
MM-MIXO-EN Ind. 0
04/2012
Mixolab
■
Adjusting the kneading arms
12. Put in place the mixer bowl the kneading arms.
13. Loosen the couplings at mixer-side ( F ).
Note: For this adjustment, the mixer bowl shall be in place and
locked. The coupler junction axles as well shall be correctly
positioned on the kneading arm axles (
G ) (there should be a
clearance of 3 mm between the junction axles and the bowl
plastic plate).
14. For adjusting the kneading arms, turn them until the nearest
points of their profile is located at 10 mm approx. from the back
edge of the bowl, see photo (
H ).
15. Tighten the couplings at bowl-side (thread locking with Loctite
222).
16. Check the good rotation by manually turning the kneading
arms from the encoder disc.
17. Reinstall the left and right Mixolab casings (see op. 1-1) , as
well as the central casing (see op. 1-2) .
6 : Motor and drive
Operation 6-9 Dismantling/installing a kneading arm coupling
Sheet: 2 / 2
Consumables:
Tools:
Loctite 222 (pink)
-
G
F
H