4
4
4-90
4-90
Parts Replacement and Cleaning > Image Formation System > Remove the Patch Sensor (front,center,rear) > Actions after Replacement
Parts Replacement and Cleaning > Image Formation System > Remove the Patch Sensor (front,center,rear) > Actions after Replacement
2) Remove the Pre-secondary Transfer Guide. Be sure not to put too much force on the Pre-
secondary Transfer Guide when removing it.
• 2 screws
x2
Secondary Transfer Guide
Grounding Cable
3) Remove the mold.
• 4 screws
• 4 bosses
Boss
x4
F-4-117
F-4-118
4) Remove the Wire Saddle, Reuse band, and Edge Saddle to make the Sensor Assembly
moving freely.
• 2 Wire Saddles
• 1 Reuse Band
• 1 Edge Saddle
x4
Edge Saddle
Wire Saddles
5) Remove the sensor desired to be replaced. (Patch Sensor (Rear) as an example)
• 2 Screws
• 1 Connector
x2
Connector
■
Actions after Replacement
When replace the Patch Senosor (center),Initialization of Patch sensor (center) is necessary.
COPIER > OPTION > IMG-MCON > P-ALPHA Input Patch Sensor alpha value
F-4-119
F-4-120