TeraStation User Manual
111
The TeraStation supports Wake on LAN, which allows it to be turned on remotely.
Before using Wake on LAN, enable it as described below.
1
In Settings, navigate to
Network
-
Settings
-
IP Address Settings
. Click
Modify Settings
.
2
Wake on LAN is now enabled. As long as it is connected to power and the network, you can turn on the TeraStation re-
motely. To turn the TeraStation on remotely, send a Wake on LAN packet to the TeraStation on UDP port 2304.
Notes:
• TS-XEL series TeraStations do not support Wake on LAN.
• After receiving the Wake on LAN packet, the TeraStation may take approximately five minutes to be ready to use.
• After power is restored from a power outage, wait five minutes before sending a Wake on LAN packet to the TeraSta-
tion.
• To use Wake on LAN, you’ll need Wake on LAN software such as AMD’s Magic Packet utility. The TeraStation does not
include Wake on LAN software.
• The TeraStation does not support using Wake on LAN and port trunking at the same time. You may use either feature,
but not both at the same time.
• On the local network, Wake on LAN packets may be sent to port 2304 on either of the TeraStation’s LAN ports. If the
TeraStation is connected to a Buffalo wireless router configured for remote access, then it may be turned on from out-
side the local network (from the WAN side). To use this feature, the Buffalo router must be connected to LAN Port 1 only
on the TeraStation. The TeraStation does not support remote WAN-side Wake on LAN if LAN Port 2 is connected to the
router.
Wake on LAN
1
Click
Enable
for
Wake on LAN
.
2
Click
Save
.
