BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 150 / 356

Fuel System
Fuel Component Servicing
150
•
Fuel return manifold to vapor separator
Remove fuel manifold retainer screws and remove
retainers from fuel injectors.
Disconnect fuel manifold fittings from fuel injector
ports, then remove the manifold assemblies.
Clean up any spilled fuel with shop towels.
Installation
Check condition of sealing O-rings on fuel mani-
fold fittings. Lubricate O-rings with outboard lubri-
cant and insert fuel manifold fittings into injector.
Both fittings must be fully seated into the injector
fuel ports.
Install retainer in the outer groove of the manifold
fittings. Install and tighten screw to a torque of 24
to 36 in. lbs. (2.7 to 4 N·m).
Install the fuel manifolds to the fuel pump assem-
bly and secure with clamps:
•
Fuel supply manifold to circulation pump.
•
Fuel return manifold to vapor separator.
1. Fuel supply manifold
2. Fuel return manifold
004189
1. Retainer screw
2. Fuel supply manifold fitting
3. Fuel return manifold fitting
004266
ENVIRONMENTAL NOTE
Dispose of fuel contaminated towels in an envi-
ronmentally responsible manner, or according to
local regulations.
1
2
2
3
1
1. Retainer
2. Manifold fitting groove
005342
1. Retainer screw
2. Fuel supply manifold fitting
3. Fuel return manifold fitting
004266
1
2
2
3
1