BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 101 / 356

101
Electrical and Ignition
Charging System Tests
6
55 V Alternator Circuit
Check battery ground cable for continuity.
With the key switch ON, check battery voltage at
battery (12 V).
Then, use Electrical Test Probe Kit, P/N 342677,
and a digital multimeter set to read 55 VDC to
check voltage on white/red wires at J2 connector
of
EMM . Voltage at EMM connector should be
approximately 30 V.
With outboard running at 1000 RPM, voltage on
white/red wires should increase to 55 V. Voltage
readings at a specific speed (RPM) should be
steady.
If there is any other reading, refer to Stator Tests
on p. 98. Inspect the stator wiring and connec-
tions. Inspect the capacitor wiring, connections,
and capacitor. Repair the wiring or replace a faulty
capacitor, stator, or
EMM .
1. J2 connector of EMM 004197
1