BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 243 / 356

243
Powerhead
Powerhead Assembly
11
est setting (two lines showing). Rotate adjustment
knob 180° to lock the stop in position.
Secure restraining jaw “A” and forcing jaw “B” to
frame.
Apply a light coat of outboard lubricant to the cor-
ners of the connecting rod and rod cap. Place
frame on connecting rod using the following pro-
cedure:
•
Position frame onto the connecting rod so the
contact area of the jaw is centered on the side
of the rod.
•
Tighten forcing screw until jaws contact con-
necting rod.
•
Slide frame down until adjustment stop contacts
the rod cap. The groove lines on the jaws must
be centered on the rod/crankpin diameter.
•
Tighten the forcing screw to a torque of 23 in.
lbs. (2.5 N·m).
IMPORTANT:
Make sure that frame is squarely
in position and that rod and cap are aligned.
Loosen both rod cap screws one-quarter turn.
Use Torquing Socket, P/N 346187, to tighten rod
cap screws in three stages:
•
Apply first torque of 40 to 60 in. lbs. (5 to 7 N·m)
to both rod cap screws.
•
Tighten screws to a torque of 20 to 22 ft. lbs. (27
to 30 N·m).
•
Apply final torque of 60 to 65 ft. lbs. (81 to 88
N·m).
1. Adjustment stop, highest setting 2287
Restraining Jaw “A” 21591
Forcing Jaw “B” 21594
1
1. Forcing screw
2. Adjustment stop
3. Groove line
005297
21605
3
2
1