BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 311 / 356

311
Trim and Tilt
Trim and Tilt Servicing
13
remove the seal protector. Slide the end cap down
the tilt rod.
Remove any lubricant from the threads on the tilt
rod, prime with
Locquic Primer , and let dry. Slide
the piston assembly onto the tilt rod. Place a new
rod O-ring over the threads.
Clean any thread-locking material from the
threads on the inside of the nut. Spray threads of
with
Locquic Primer and let dry. Apply a small
amount of Nut Lock to the threads. Slide the
washer over the threads and install the nut.
Torque to 58 to 87 ft. lbs. (79 to 118 N·m).
To ensure that the tilt piston has been properly
assembled and the impact relief balls are properly
seated, apply
Power Trim/Tilt & Steering Fluid on
top of the tilt piston. Fluid should not leak past the
impact relief balls while seated. If fluid does leak,
disassemble the piston assembly and inspect the
relief ball seats. Set the tilt rod assembly aside.
1. Tilt Cylinder Seal Protector 41824
1. O-ring 41816
1
1
41783
41828