BRP EVINRUDE E-TEC BE225HGXABA, Manual

Page: 30 / 356

30
Routine Service
Adjustments
Clamp Removal
Method 1: Position Oetiker pincers across clamp
ear and cut clamp.
Method 2: Lift end of stepless clamp with screw-
driver.
Method 3: Use Oetiker pincers (pliers) to grip
clamp. Pull clamp off of connection and discard.
Adjustments
Tilt Limit Switch Adjustment
Adjust the tilt limit switch on all new outboard
installations.
Check the clearance between outboard(s) and the
boat’s motor well and transom area. Tilt out-
board(s) to highest point of clearance and turn the
steering system lock to lock.
If the outboard contacts the boat's motor well
when fully tilted, adjust the tilt limit cam to reduce
full-tilt position.
Place the outboard in normal operating position.
1. 000108
1. 000090
1. 000091

WARNING
If the outboard does not clear all boat parts
when tilted fully or turned side to side, safety
related parts could be damaged in the course
of such outboard movement. Injuries could
result from loss of boat control.

WARNING
Adjusting the tilt limit cam will NOT prevent
the outboard from tilting fully and contacting
the motor well if the gearcase hits an object at
high speed. Such contact could damage the
outboard and boat and injure boat occupants.
NOTICE
The tilt limit cam will not prevent the outboard
from overriding the adjustment if the out-
board is tilted manually.
DR3916